Refrigeration Basics Quiz June 22, 2022, 1:27 am

Related Tech Tips

Pressure / Enthalpy Diagram Example
This article was written by my buddy and Canadian Supertech Tim Tanguay. Thanks, Tim! This P/E chart shows R410a at 100°F saturated condensing temp, 10°F SC, 40°F saturated suction temp, 20°F SH at the compressor. The green highlighted thumb shape is the saturation zone. Everything that occurs in the saturation zone is a latent (change […]
Read more
You're Grounded
One of the most common questions we get from techs is about using a voltmeter to diagnose a high voltage circuit. It's especially tricky when a tech is used to working on a low-voltage or 120V circuit, where there is a clear “hot” side of the circuit and a clear “grounded” side of the circuit. […]
Read more
What the Heck is a Friction Rate?
Friction rate is a value located on a ductulator. We use it during the design phase of a duct system to predict the operating static pressure of a duct system. The challenge with friction rate is that it is often misapplied by folks using a rule of thumb (ROT). In order to apply friction rate properly, […]
Read more

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from