HVAC work is never just “HVAC” work. One minute you're brazing copper, and the next you're troubleshooting a blown fuse in a disconnect or running a new whip to a condenser. Because our trade is so varied, you never know what you're going to find when you open a service panel or crawl into an […]

Some quick basics: An ohmmeter is used to measure the resistance to electrical flow between two points. The ohmmeter is most commonly used to check continuity. Continuity is not a “measurement” as much as it is a yes/no statement. To say there is continuity is to say that there is a good electrical path between […]

How many times have you looked at the bottom right-hand side of an evaporator coil and seen all sorts of rust, even on a fairly new coil? You may have noticed that many evaporator coils and even some condenser coils will start to corrode where the galvanized steel endplates touch the copper U-bends of the […]

 Mark Tozzi from Carrier comes on the HVAC School podcast to talk about unique HVAC incentives in K-12 schools. When schools closed down during COVID-19 lockdowns, a new series of incentives came out for schools. Many of these incentives include access to technology, and improvements to HVACR equipment are covered under those programs. Schools […]