HVAC work is never just “HVAC” work. One minute you're brazing copper, and the next you're troubleshooting a blown fuse in a disconnect or running a new whip to a condenser. Because our trade is so varied, you never know what you're going to find when you open a service panel or crawl into an […]

Some quick basics: An ohmmeter is used to measure the resistance to electrical flow between two points. The ohmmeter is most commonly used to check continuity. Continuity is not a “measurement” as much as it is a yes/no statement. To say there is continuity is to say that there is a good electrical path between […]

How many times have you looked at the bottom right-hand side of an evaporator coil and seen all sorts of rust, even on a fairly new coil? You may have noticed that many evaporator coils and even some condenser coils will start to corrode where the galvanized steel endplates touch the copper U-bends of the […]

Gurminder Sidhu joins us from NATE to talk about what NATE is all about and bring us some news about the new changes and improvements. NATE was created for the industry by the industry; the organization arose from a need to promote education and standardize HVAC qualifications. Today, NATE continues to address the industry's needs […]