491762830

Comments

Related Tech Tips

Oxyacetylene Torches: Tips and Operation
    Everyone in the HVAC/R trade uses some type of torch to braze or solder alloys together. So, what is the proper way to handle an oxyacetylene torch? It turns out that there’s more than one right answer. Depending on which torch rig you use, the manufacturer’s manuals for operation may vary.  Everyone (hopefully) knows […]
Read more
Heat Pump Defrost Sensor vs. Thermostat
When you work on a heat pump system and want to test defrost, you can follow many different test procedures to test the board and sensors. Most involve “forcing” a defrost by shorting out pins on the board or advancing the time of the defrost initiation and installing a factory-provided pin jumper. Lots of pins […]
Read more
An even EASIER way to check capacitors
In a previous article, we covered the standard way to check capacitors under load. I am now going to give you an even easier test. A properly functioning PSC (permanent split capacitor) or CSCR (capacitor start capacitor run) motor should have a power factor of very close to 1 if they have a properly sized […]
Read more
loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from