289473560

Comments

Related Tech Tips

Pitch on Line Penetrations
Most techs and installers know that drains need to be pitched. I use the rule of thumb that drain lines should generally be pitched 1/4″ per foot of horizontal run. One thing that can easily be forgotten is pitching wall penetrations when drilling. It's as simple as drilling with a slight upward angle if drilling […]
Read more
The "Other" Pressure Switch
The chart above is from a Carrier heat pump, and it lists some common accessories. I have heard this common pressure switch (last on the list) called a low-pressure switch (because it opens on fall in pressure) and a high-pressure switch (because it's in the liquid line), but RARELY do I hear it called its […]
Read more
Motor Speed - The Basics
How does a typical single phase motor know how fast to run? Typical induction motors are dependent of the electrical cycle rate of the entering power (measured in hertz) for their speed. Our power in the US makes one complete rotation from positive electrical peak to positive peak 60 times per second or 60hz (50hz […]
Read more
loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from