284697053

Comments

Related Tech Tips

Pitch on Line Penetrations
Most techs and installers know that drains need to be pitched. I use the rule of thumb that drain lines should generally be pitched 1/4″ per foot of horizontal run. One thing that can easily be forgotten is pitching wall penetrations when drilling. It's as simple as drilling with a slight upward angle if drilling […]
Read more
Pool Heat Pumps, The Basics
Note: My brother Nathan wrote this a few years back, and I only did some minor editing. A pool heat pump is essentially a water-cooled air conditioner in reverse. It usually has a large air evaporator on the outside that looks like a condenser coil and a heat exchanger (usually tube-in-tube) on the inside. A […]
Read more
Do You Replace the Contactor and Capacitor With a New Compressor
Replacing a compressor is expensive, time-consuming, and physically taxing. If we are replacing a compressor, I want us to be doggone sure we aren't going to be dealing with the same thing again, and this often includes a shiny new contactor and capacitor (on single-phase units). We received a comment recently that called out the […]
Read more
loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from