207958143

Comments

Related Tech Tips

Heat Pump Defrost Sensor vs. Thermostat
When you work on a heat pump system and want to test defrost, you can follow many different test procedures to test the board and sensors. Most involve “forcing” a defrost by shorting out pins on the board or advancing the time of the defrost initiation and installing a factory-provided pin jumper. Lots of pins […]
Read more
Ohms/Continuity Basics
Some quick basics – An ohmmeter is used to measure the resistance to electrical flow between two points. The ohmmeter is most commonly used to check continuity. Continuity is not a “measurement” as much as it is a yes/no statement. To say there is continuity is to say that there is a good electrical path […]
Read more
Flash Gas
When we say that there is “flash gas” at a particular point in the system, it can either be a bad thing or a good thing, depending on where it is occurring. Flash gas is just another term for boiling. It is perfectly normal (and required) that refrigerant “flashes” or begins boiling directly after the […]
Read more
loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from