053289146

Comments

Related Tech Tips

Swaging Copper: Best Practices
Swaging copper is one of the most common practices in our trade when it comes to brazing pipes. Yes, it sometimes makes more sense to slap on a coupling or street ell fitting, but most of the time, cutting your braze joints in half is much easier and faster during an install or repair.  So, […]
Read more
5 Install Mistakes that Kill Systems
When we install systems, we should have three main goals in mind: maximizing longevity, efficiency, and capacity. We want our units to work as long as possible, use the lowest amount of energy, and move the greatest amount of BTUs possible with a proper mix of sensible and latent heat transfer. Unfortunately, some installation practices […]
Read more
Equivalent Length Merry-Go-Round
I recently read a tech tip by Matt Bruner about using the Manual D process. In the article, he designed a duct system for a small job using a ducted mini-split. One thing I noticed about his design was that the supply and return duct velocity was fairly low compared to the arbitrary 900-feet-per-minute supply […]
Read more
loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from