Thomas J. Siegmann HVAC/R Evacuation Quiz September 22, 2021, 4:17 am

Related Tech Tips

Can Pulling a Vacuum too Fast Freeze Water/Moisture?
First, I want to give credit where credit is due. This post is made possible by the fantastic demonstration video by Neil Comparetto that I embedded below. Before you get bored and stop reading, I want to get the conclusion out in the air. Ice can form in a vacuum, but I still advise pulling a […]
Read more
Heat Pump Defrost Sensor vs. Thermostat
When you work on a heat pump system and want to test defrost, you can follow many different test procedures to test the board and sensors. Most involve “forcing” a defrost by shorting out pins on the board or advancing the time of the defrost initiation and installing a factory-provided pin jumper. Lots of pins […]
Read more
Pre-Cleaning Copper
Sometimes, we can focus on the more complicated aspects of a system and parts installation—like evacuation and flowing nitrogen—and forget the simple and critical common-sense steps to keep contaminants out of the system. One of these is pre-cleaning the tubing and connection before cutting or unsweating. For example: If you are replacing a coil, use […]
Read more

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from