System and Duct Design January 31, 2024, 8:58 pm

Comments

Related Tech Tips

Boiler Basics Part 4 - Piping
Please note: There have been some legitimate questions about a few of the points in this article and the diagrams. While Justin Skinner is an experienced tech and totally qualified to write this article, we will be specifically looking into the question of the best location of the circulator pump and addressing the “point of […]
Read more
Micron Gauges Gone Wild
We've been getting many questions on micron gauges that are ”going haywire” or reading in the micron range, even at atmospheric pressure. First, micron gauges measure absolute pressure, so you can’t ”zero” them out. They use tiny, very sensitive sensors that are calibrated to air, not refrigerant, so anytime refrigerant gets into the gauge, it's […]
Read more
Equipment Grounding
The grounding and bonding process is important, and it's a fairly broad topic. In HVAC/R, we generally just need to make sure that we properly connect the conductors (wires) provided to the proper connection points in the equipment and occasionally the disconnects. These connection lugs or green screws are rated for grounding so long as […]
Read more
loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from