Sam Basic Refrigeration Circuit June 24, 2022, 4:22 am

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Related Tech Tips

Pre-Cleaning Copper
Sometimes, we can focus on the more complicated aspects of a system and parts installation—like evacuation and flowing nitrogen—and forget the simple and critical common-sense steps to keep contaminants out of the system. One of these is pre-cleaning the tubing and connection before cutting or unsweating. For example: If you are replacing a coil, use […]
Read more
Furnace Air Temperature Rise
Every gas furnace data plate/tag has a specification for the temperature rise through that furnace. It is shown in a range, like 50-80° or 45-75°. Those two numbers are the lowest recommended temperature rise, and the highest allowed temperature rise through the furnace is usually a 30° difference. When possible, we want to get the rise […]
Read more
Cycle Rate Settings - A Quick Review
Most controls and thermostats will have some sort of cycle rate per hour setting that kicks in to prevent over-cycling once the setpoint is reached. These cycle settings don't kick in until the system starts achieving setpoint, so don't worry if it will shut off if it's set to 70° in heat mode and it's […]
Read more
loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from