Let's take a walk through the startup and commissioning procedure of a conventional or “single” refrigeration condensing unit. We’re going to start with a unit that is fully piped in and has been pressurized for leak and strength testing. For brevity, we are going to assume a basic familiarity with industry standards, company and customer […]

There is a common belief in the trade that the higher the subcooling, the better the system efficiency because lower liquid line temperature means less flash gas. This statement is only partially true and can lead to some confusion among techs. Subcooling is a temperature decrease below the condensing temperature of the refrigerant that occurs […]

In a previous article, we covered the standard way to check capacitors under load. I am now going to give you an even easier test. A properly functioning PSC (permanent split capacitor) or CSCR (capacitor start capacitor run) motor should have a power factor of very close to 1 if they have a properly sized […]