Phil Peterson Basic Refrigerant Circuit Course November 26, 2022, 8:24 am

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Related Tech Tips

ACFM, SCFM, & Baseball dents
This is a VERY in-depth look at ACFM vs. SCFM and why it matters to airflow measurement from Steven Mazzoni. Thanks, Steve! Imagine your job is to figure out how fast baseballs were traveling before they hit a sheet-rock wall. The only method you have is to measure the depth of the dent left in […]
Read more
Properly Deburring (Reaming)
Deburring copper tubing (often called reaming) is the practice of running a blade around the inside of tubing after you cut it to remove the burr edge from the inside. It's an important practice and should be performed whenever possible. Deburring reduces turbulence inside the lines, as burrs can cause turbulence. HOWEVER… YOU MUST MAKE […]
Read more
Technician Head Trash
It's Friday at 6 PM. The schedule is clear, as far as you can tell. Other guys have been getting cleared right and left, so you call in standby. Five minutes pass. Ten minutes pass. You check in again, and sure as &%$#, there it is! You get sent across town to another call that […]
Read more
loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from