Pat Basic Electrical Circuits June 17, 2021, 1:20 am

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Related Tech Tips

Properly Deburring (Reaming)
Deburring copper tubing (often called reaming) is the practice of running a blade around the inside of tubing after you cut it to remove the burr edge from the inside. It's an important practice and should be performed whenever possible. Deburring reduces turbulence inside the lines, as burrs can cause turbulence. HOWEVER… YOU MUST MAKE […]
Read more
4 Reasons NEVER to Make Excuses
We all know what excuses are. They tend to sound like, “I would’ve done a better job if I’d just had the right tools!” or “I would have found that disconnected duct if I weren't dispatched at 6 PM!” Some people probably say, “Those aren’t excuses. Those are reasons!” OK, sure, we can call them […]
Read more
Ball Bearing vs. Sleeve Bearing Motors
One aspect of motor selection that can get overlooked is motor bearings, and it can have big consequences. Sleeve bearings are most common in residential and light commercial applications because they are less expensive and quieter. They don't have rolling “balls” but rather rely on a thin film of oil on metal sleeves. Sleeve bearings […]
Read more
loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from