Nabeel Malik Refrigeration Basics Quiz August 6, 2021, 4:49 pm

Related Tech Tips

Cycle Rate Settings - A Quick Review
Most controls and thermostats will have some sort of cycle rate per hour setting that kicks in to prevent over-cycling once the setpoint is reached. These cycle settings don't kick in until the system starts achieving setpoint, so don't worry if it will shut off if it's set to 70° in heat mode and it's […]
Read more
Properly Deburring (Reaming)
Deburring copper tubing (often called reaming) is the practice of running a blade around the inside of tubing after you cut it to remove the burr edge from the inside. It's an important practice and should be performed whenever possible. Deburring reduces turbulence inside the lines, as burrs can cause turbulence. HOWEVER… YOU MUST MAKE […]
Read more
Subcooling vs. Liquid Line Temperature
There is a common belief in the trade that the higher the subcooling, the better the system efficiency because lower liquid line temperature means less flash gas. This statement is only partially true and can lead to some confusion among techs. Subcooling is a temperature decrease below the condensing temperature of the refrigerant that occurs […]
Read more

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from