When tightening down a blower wheel or a fan blade on a motor shaft, ONLY tighten it on the flat of the shaft. If you have more than one screw but only one flat surface on the shaft, only tighten the one set screw. Also… Refrain from over-tightening set screws; they need to bite into […]

In many cases when a low-voltage or control circuit blows a fuse, it's because one of the circuits is shorted to ground or common. That may happen because of rubbed-out wires, shorted components or boards, etc. Routing wires sensibly and using proper grommets to avoid rubouts and shorts will help prevent those problems. Less commonly, […]

This article was written by Austin Higgins, an experienced commercial service tech from Iowa. Thanks, Austin! Ice machines and limescale Any seasoned refrigeration technician knows that ice machines can be extremely finicky contraptions. Modern commercial ice makers have become a complex symphony of tubing, valves, pumps, and water directed by advanced microprocessor control boards. Newer […]