Most controls and thermostats will have some sort of cycle rate per hour setting that kicks in to prevent over-cycling once the setpoint is reached. These cycle settings don't kick in until the system starts achieving setpoint, so don't worry if it will shut off if it's set to 70° in heat mode and it's […]

Travel back in time with me to 2001. I was a young tech, proving my salt out there in the big world of commercial RTU maintenance. One of the steps in the Fall PM list was “test aux heat,” and by golly, that's what I was going to do! I was on the roof of […]

This article was submitted by Genry Garcia of Comfort Dynamics, Inc. It is the final part of his series on zonal pressure diagnostics. Thanks, Genry! Updated 3/4/2022 Picking up where we left off in part 2 of the series, we discussed how a pressure reading from an attached zone indicates only the ratio of the […]