Matt Basic Electrical Circuits September 10, 2022, 11:07 pm

Related Tech Tips

The Learning Mindset - It Isn't Obvious Until It Is
Note: This short series is on the mindset of learning (and teaching), not really a “tech tip,” per se. We will be back to the tech tips in a few days.  I've heard and repeated these phrases countless times over the years, both at home and work: That should be obvious. It's just common sense. […]
Read more
Take a Deep Breath: Respiratory Hazards in HVAC
DISCLAIMER: HVAC School is NOT an official OSHA safety training resource! Although we provide safety tips in good faith, our website is not a substitute for safety training from an authorized OSHA training source.   When most people think about respiratory devices, their minds probably jump to soldiers wearing gas masks in warfare, hazardous waste […]
Read more
5% vs. 15% Silver Solder (Brazing Rod)
First, let's get something straight: BRAZING is when you use a filler rod that isn't the same material as the base metal but melts ABOVE 840°F. Soldering is the same but at temperatures BELOW 840°F. With HVAC rods melting at around 1200°F, it confuses me why we usually call it “silver solder” but also often call it […]
Read more

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from