Lee Botha Basic Refrigerant Circuit Course June 26, 2021, 6:25 pm

Related Tech Tips

Adiabatic Cooling, Blower Settings, and Why You Care
Just so you don't get bored and quit reading, let's get straight to the point. When the blower runs for more than a few minutes after the system has cycled off in cool mode, the air may continue to be “cooler” (lower sensible temperature) coming out of the supply, but the heat content of the […]
Read more
Why and how to adjust a TXV/TEV
As we discussed in an earlier podcast, a TXV is designed to maintain a specified and constant superheat at the evaporator coil outlet. It does this through a balance of forces between the bulb pressure (opening force), equalizer pressure (closing force), and spring pressure (closing force). Spring pressure can be adjusted on some valves, but […]
Read more
Lockout/Tagout Basics
DISCLAIMER: HVAC School is NOT an official OSHA safety training resource! Although we provide safety tips in good faith, our website is not a substitute for safety training from an authorized OSHA training source. Locking out and tagging equipment is one of the most basic safety procedures in general industry and maintenance work, especially in […]
Read more

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from