Swaging copper is one of the most common practices in our trade when it comes to brazing pipes. Yes, it sometimes makes more sense to slap on a coupling or street ell fitting, but most of the time, cutting your braze joints in half is much easier and faster during an install or repair.  So, […]

You may have noticed that 3/8 liquid lines are generally the norm in equipment 5 tons and under. We went to a job recently where the system had a 1/2″ liquid line, and it got me thinking about the ramifications of going larger or smaller on the liquid line. Liquid Line Basics The liquid line […]

Deburring copper tubing (often called reaming) is the practice of running a blade around the inside of tubing after you cut it to remove the burr edge from the inside. It's an important practice and should be performed whenever possible. Deburring reduces turbulence inside the lines, as burrs can cause turbulence. HOWEVER… YOU MUST MAKE […]