Although there are various line lift, sizing, and trapping guidelines depending on oil and refrigerant type, there is one guideline we can all understand easily and remember to apply. This guideline is to slope suction lines towards condensing units/compressors. Keeping the suction line sloped toward the compressor, especially with long overhead lines, helps return the […]

Service calls about condensing fan motor failure are quite common. Even though fan motor replacement is a standard procedure for residential split systems, it requires careful attention to safety and detail.  This article will give you a step-by-step guide to replacing condensing fan motors. Along the way, we will also explain a few best practices […]

Friction rate is a value located on a ductulator. We use it during the design phase of a duct system to predict the operating static pressure of a duct system. The challenge with friction rate is that it is often misapplied by folks using a rule of thumb (ROT). In order to apply friction rate properly, […]