DISCLAIMER: HVAC School is NOT an official OSHA safety training resource! Although we provide safety tips in good faith, our website is not a substitute for safety training from an authorized OSHA training source. Locking out and tagging equipment is one of the most basic safety procedures in general industry and maintenance work, especially in […]

  Image Courtesy of Eaton SNAP ‘N SHIELD Piping support is covered in Section 305 of the IMC (International Mechanical Code). Once again, the IMC isn't binding, but it is what most local codes are based on. Piping / Tubing Material Maximum Horizontal Distance Between Support Maximum Vertical Distance Between Support Copper Tubing 1 1/4″ […]

If you are used to simple, straight-cool split systems, you know that the low voltage to the outdoor unit is usually VERY simple. In many cases, there's just a Y (contactor power) and a C (common) connected to the outdoor unit. When the condensing unit controls are strictly two-wire low voltage, there is no continuous […]