This photo is of a blower door test we performed at my own house using a Retrotec blower door. You will notice the 15-passenger van outside the window, which is a dead giveaway. A blower door is used to measure the tightness of a building and is often discussed in terms of an ACH50 number. […]

Introduction Replacing a reversing valve is either every technician’s dream or nightmare. The sheer amount of brazing involved in confined spaces will inspire either delight or nightmares about the upcoming valve replacement. Fortunately, these emotional highs and lows are uncommon because we don’t diagnose and replace bad reversing valves very often.  That itself poses a […]

In residential, most techs and installers size the suction (vapor) and liquid lines to the stubs on the equipment. In larger built-up systems, sizing the piping is rarely the responsibility of the technician. But what happens if we show up to a job where the lines cannot be (reasonably) replaced because the size is different? […]