Imad Alshammari High-Efficiency Furnace Quiz April 7, 2022, 12:12 pm

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Related Tech Tips

Low Airflow - Beyond the Obvious
Every now and then, a tech will call me and give me the same story of woe. They're working on a system and have the following readings: Low superheat Low suction pressure Low head pressure They'll reassure me that the system airflow is correct. So, what could possibly be wrong? I'll ask how they could […]
Read more
The Friction Rate Chart (and What it Means)
A lot of proper duct design comes down to an understanding of available static pressure and friction rate. We've covered this topic several times on this site and the podcast, but I wanted to focus on this ACCA chart specifically (shown above). If you want a deep dive, I highly recommend listening to my podcast […]
Read more
Properly Deburring (Reaming)
Deburring copper tubing (often called reaming) is the practice of running a blade around the inside of tubing after you cut it to remove the burr edge from the inside. It's an important practice and should be performed whenever possible. Deburring reduces turbulence inside the lines, as burrs can cause turbulence. HOWEVER… YOU MUST MAKE […]
Read more
loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from