HVAC/R Evacuation Quiz October 30, 2021, 8:16 pm

Related Tech Tips

Ohms/Continuity Basics
Some quick basics – An ohmmeter is used to measure the resistance to electrical flow between two points. The ohmmeter is most commonly used to check continuity. Continuity is not a “measurement” as much as it is a yes/no statement. To say there is continuity is to say that there is a good electrical path […]
Read more
Cycle Rate Settings - A Quick Review
Most controls and thermostats will have some sort of cycle rate per hour setting that kicks in to prevent over-cycling once the setpoint is reached. These cycle settings don't kick in until the system starts achieving setpoint, so don't worry if it will shut off if it's set to 70° in heat mode and it's […]
Read more
Diagnosing ECM & X13 Motors
First, let's give proper credit. Most of the best practices and tools for diagnosing ECM and X13 motors come from Regal/Genteq and their site, thedealertoolbox.com, and their app, The Dealer Toolbelt. Your best bet is to follow the practices shown there and use their TECInspect diagnostic tool shown below. Here is the general process to […]
Read more

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from