HVAC/R Evacuation Quiz June 6, 2021, 5:53 pm

Comments

Related Tech Tips

Ohms/Continuity Basics
Some quick basics – An ohmmeter is used to measure the resistance to electrical flow between two points. The ohmmeter is most commonly used to check continuity. Continuity is not a “measurement” as much as it is a yes/no statement. To say there is continuity is to say that there is a good electrical path […]
Read more
Lifting Techniques Part 3 - Complex Block & Tackle
This is Part 3 series by Senior Refrigeration Tech (and prolific writer) Jeremy Smith. Pay attention to this one, folks. I know rigging and safe lifting practices may be boring to some of you, but it could very well save your back or your life. Disclaimer This article is written by a technician representing his […]
Read more
You're Grounded
One of the most common questions we get from techs is about using a voltmeter to diagnose a high voltage circuit. It's especially tricky when a tech is used to working on a low-voltage or 120V circuit, where there is a clear “hot” side of the circuit and a clear “grounded” side of the circuit. […]
Read more
loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from