Get Tech Tips
Subscribe to free tech tips.
F Basic Electrical Theory September 17, 2021, 5:02 pm
Related Tech Tips

When brazing and soldering, we have a few things we need to accomplish to make a proper connection: We can't overheat the joint until it overheats the base metal or the flux where applicable. We must bring the entire joint above the melting temperature of the brazing alloy. Draw the alloy deep into the joint. […]
Read more
Most techs and installers know that drains need to be pitched. I use the rule of thumb that drain lines should generally be pitched 1/4″ per foot of horizontal run. One thing that can easily be forgotten is pitching wall penetrations when drilling. It's as simple as drilling with a slight upward angle if drilling […]
Read more
Pump down solenoid valves are commonplace for any refrigeration technician. They are energized with the compressor still running, shutting off flow in the liquid line so that the refrigerant is pumped into the condenser and receiver. The compressor will then shut off once a low-pressure switch opens the circuit when the pressure falls below a […]
Read more