I get questions all the time about performing “load calculations” and “rules of thumb” or how to do it properly. This article isn't about load calculation, but the only good answer is to find a quality ACCA-approved Manual J software and get used to using it. You may have heard from others in the field […]

Many of us are aware that X13 and Fully variable motor failure has peaked over the last few years, and I'm sure there are multiple reasons for that. One of the reasons is fairly simple and can be traced back to two simple installation and service practices that can be easily implemented. Seal all air […]

This article was written by senior furnace tech Benoît (Ben) Mongeau. Ben hails from the frozen tundra of Ontario, Canada, where high-efficiency gas furnaces are commonplace. While some codes and practices may be different from the US, I find that most of it is common sense and translates pretty well. One glaring difference between Canada […]