Brandon Refrigeration Basics Quiz November 7, 2021, 5:15 am

Related Tech Tips

Subcooling vs. Liquid Line Temperature
There is a common belief in the trade that the higher the subcooling, the better the system efficiency because lower liquid line temperature means less flash gas. This statement is only partially true and can lead to some confusion among techs. Subcooling is a temperature decrease below the condensing temperature of the refrigerant that occurs […]
Read more
Pressure / Enthalpy Diagram Example
This article was written by my buddy and Canadian Supertech Tim Tanguay. Thanks, Tim! This P/E chart shows R410a at 100°F saturated condensing temp, 10°F SC, 40°F saturated suction temp, 20°F SH at the compressor. The green highlighted thumb shape is the saturation zone. Everything that occurs in the saturation zone is a latent (change […]
Read more
Multi Tap Primary Transformers
Have you ever seen a low-voltage transformer like the one shown above? It has multiple input (primary) taps for a good reason. It is common to find three-phase and single-phase equipment rated to operate on both 240v and 208v power. That is because three-phase power can either be 208v leg to leg when the building […]
Read more

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from