Basic Refrigerant Circuit Course August 4, 2021, 6:30 pm

Related Tech Tips

Proper Liquid Line Drier Location
Diagram above by Carrier  It's really easy to put a liquid line drier in the proper location, but it's still more commonly installed in the WRONG location. Namely, people install it right at the condensing unit. (OK, it isn't that big of a deal, but I needed some dramatic emphasis.) Installing it at the indoor […]
Read more
4-20ma Control Basics
Back in the “good old days,” controls were all analog and mechanical, which simply means that they acted in a directly connected and variable manner based on a change in force. Both pneumatic (air pressure) or hydraulic (fluid pressure) systems are examples of mechanical or analog controls. When the pressure increased or decreased on a […]
Read more
Properly Deburring (Reaming)
Deburring copper tubing (often called reaming) is the practice of running a blade around the inside of tubing after you cut it to remove the burr edge from the inside. It's an important practice and should be performed whenever possible. Deburring reduces turbulence inside the lines, as burrs can cause turbulence. HOWEVER… YOU MUST MAKE […]
Read more

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from