Basic Electrical Theory September 9, 2021, 1:40 am

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Related Tech Tips

Negative Superheat? Time to Check Your Tools
I was fresh out of school, working as an apprentice at my first real HVAC job, and I was listening in on a shop conversation between a few techs. They were talking about finding so many overcharged systems. One of the techs turns to me and says, “I had a unit yesterday that was so […]
Read more
Tubing and Piping Support
  Image Courtesy of Eaton SNAP ‘N SHIELD Piping support is covered in Section 305 of the IMC (International Mechanical Code). Once again, the IMC isn't binding, but it is what most local codes are based on. Piping / Tubing Material Maximum Horizontal Distance Between Support Maximum Vertical Distance Between Support Copper Tubing 1 1/4″ […]
Read more
Capacitor Testing and Replacement Procedure
  ❶ Understand What a Run Capacitor Does The run capacitor provides continuous phase-shifted current to the motor start winding, allowing the motor to run: With the design efficiency In the right direction With the appropriate torque With near “unity” power factor (power factor near 1.0) If the run capacitor is failed, the motor often […]
Read more
loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from