Basic Electrical Theory April 3, 2022, 4:56 am

Related Tech Tips

Tubing and Piping Support
  Image Courtesy of Eaton SNAP ‘N SHIELD Piping support is covered in Section 305 of the IMC (International Mechanical Code). Once again, the IMC isn't binding, but it is what most local codes are based on. Piping / Tubing Material Maximum Horizontal Distance Between Support Maximum Vertical Distance Between Support Copper Tubing 1 1/4″ […]
Read more
Don't Use Barometric Pressure For Calibration
Take a look at the screenshots above. The one on the left is for Death Valley at 282′ below sea level, and the one on the right is Denver, CO, at 5,280′ above sea level. Notice the barometric pressure values; they are almost the same. That means that barometric pressure is corrected or “normalized” to […]
Read more
The Learning Mindset - It Isn't Obvious Until It Is
Note: This short series is on the mindset of learning (and teaching), not really a “tech tip,” per se. We will be back to the tech tips in a few days.  I've heard and repeated these phrases countless times over the years, both at home and work: That should be obvious. It's just common sense. […]
Read more

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from