arnaldo Basic Electrical Circuits December 16, 2021, 4:22 pm

Related Tech Tips

Changing Liquid Filter/Drier Cores Tip
This tip comes from market refrigeration and controls technician Kevin Compass. Thanks, Kevin! A little tip when changing liquid cores: If you start pumping them down, begin bypassing discharge gas into the shell to warm it up, push out the remaining liquid, and bring the shell above the dew point so that it doesn't sweat […]
Read more
Fan Blade Shroud Depth
When a system has abnormally high head pressure (high condensing temperature over ambient) and compression ratio, one of the easiest things to look for is a dirty condenser coil. More often than not, that will be the cause. However… There is another category of issues that can cause high condensing temperature (high head pressure), but these […]
Read more
Lifting Techniques Part 2 - Pulleys
This is Part 2 series by Senior Refrigeration Tech (and prolific writer) Jeremy Smith. Pay attention to this one, folks. I know rigging and safe lifting practices may be boring to some of you, but it could very well save your back or your life. Disclaimer This article is written by a technician representing his […]
Read more

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from