When you work on a heat pump system and want to test defrost, you can follow many different test procedures to test the board and sensors. Most involve “forcing” a defrost by shorting out pins on the board or advancing the time of the defrost initiation and installing a factory-provided pin jumper. Lots of pins […]

This topic came up because I was testing out the new MR45 digital recovery machine. That machine goes off by itself when it hits a 20″ Hg vacuum. It's a cool feature, but it is good to know when that level of vacuum is overkill and when it's not enough according to EPA requirements. You […]

When brazing and soldering, we have a few things we need to accomplish to make a proper connection: We can't overheat the joint until it overheats the base metal or the flux where applicable. We must bring the entire joint above the melting temperature of the brazing alloy. Draw the alloy deep into the joint. […]