Alfred Thomas Moore III Basic Refrigerant Circuit Course December 19, 2021, 1:31 am

Related Tech Tips

False Alarms: The Legacy of Phosgene Gas
We’ve all been in the unenviable position of unsweating a compressor and getting blasted in the eyes with a waft of gas that smells like burning sulfur from the pits of Hades. As we stagger back, covering our noses and holding our breaths, memories of the phrase “phosphene gas” from trade school or World War […]
Read more
It Has a Flat For a Reason
When tightening down a blower wheel or a fan blade on a motor shaft, ONLY tighten it on the flat of the shaft. If you have more than one screw but only one flat surface on the shaft, only tighten the one set screw. Also… Refrain from over-tightening set screws; they need to bite into […]
Read more
Control Voltage Overamp - The Less Usual Cause
In many cases when a low-voltage or control circuit blows a fuse, it's because one of the circuits is shorted to ground or common. That may happen because of rubbed-out wires, shorted components or boards, etc. Routing wires sensibly and using proper grommets to avoid rubouts and shorts will help prevent those problems. Less commonly, […]
Read more

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from