Alan Juan Halgreen Basic Refrigerant Circuit Course September 6, 2021, 9:56 am

Related Tech Tips

32° Saturation (Evap Temperature)
Evaporator temperatures below 32° are common and acceptable in refrigeration; that's why there is a defrost sequence. In a heat pump running in heat mode, it's the same; freezing is a part of the process, and defrost is necessary. In comfort cooling, we can't allow the evaporator to get below 32°, or it will freeze. […]
Read more
Using Power Factor to Check Capacitors Under Load
Capacitors are traditionally tested with a capacitance meter (commonly found as a function within a multimeter), with the component taken entirely out of the circuit. “Bench testing,” as this method is referred to, is hands-down the safest method of checking capacitance in microfarads. All other methods require the capacitor to be wired into the circuit […]
Read more
Hot Pull Down and What it Means
If you work in refrigeration, you may have heard the term “hot pull down.” This phrase describes a condition where the load on the evaporator is above design due to the box temperature or the temperature of the product in the box being higher than it would normally be. My grandpa called me a few […]
Read more

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from