Measuring Air Flow – Static / Capacity & ECM Motors Part 1 w/ Jim Bergmann

In this episode Jim Bergmann covers static pressure, measuring delivered capacity and ECM motor considerations

Related Tech Tips

Subcool and Liquid Line Length
The primary role of setting an appropriate level of subcooling is to ensure that we deliver a full line of liquid refrigerant to the metering device. We want to do this at: A pressure differential required by the metering device At a temperature and pressure no higher than required for maximum capacity and efficiency But […]
Read more
An even EASIER way to check capacitors
In a previous article, we covered the standard way to check capacitors under load. I am now going to give you an even easier test. A properly functioning PSC (permanent split capacitor) or CSCR (capacitor start capacitor run) motor should have a power factor of very close to 1 if they have a properly sized […]
Read more
Drain Cleaning Protocol
This article is primarily based on HVAC School’s “Drain Cleaning – More To It Than We Think,” hosted by Bryan Orr and featuring Corey Cruz and Mike Klokus. You can listen to that episode HERE. How hard could it be to clean a drain? The slime should just wash away if you flush the drain […]
Read more

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from