Is Ultrasonic Leak Detection Best?

Related Tech Tips

Don't Use Barometric Pressure For Calibration
Take a look at the screenshots above. The one on the left is for Death Valley at 282′ below sea level, and the one on the right is Denver, CO, at 5,280′ above sea level. Notice the barometric pressure values; they are almost the same. That means that barometric pressure is corrected or “normalized” to […]
Read more
What the Heck is a Friction Rate?
Friction rate is a value located on a ductulator. We use it during the design phase of a duct system to predict the operating static pressure of a duct system. The challenge with friction rate is that it is often misapplied by folks using a rule of thumb (ROT). In order to apply friction rate properly, […]
Read more
Using Power Factor to Check Capacitors Under Load
Capacitors are traditionally tested with a capacitance meter (commonly found as a function within a multimeter), with the component taken entirely out of the circuit. “Bench testing,” as this method is referred to, is hands-down the safest method of checking capacitance in microfarads. All other methods require the capacitor to be wired into the circuit […]
Read more

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from