Brazing Basics and Tips

In this episode Bryan talks about brazing safety, regulator settings, torch positioning, flowing nitrogen, heat control and more….

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Related Tech Tips

Boiler Basics Part 4 - Piping
Please note: There have been some legitimate questions about a few of the points in this article and the diagrams. While Justin Skinner is an experienced tech and totally qualified to write this article, we will be specifically looking into the question of the best location of the circulator pump and addressing the “point of […]
Read more
Impacts of Compression on Temperature
Many in our industry can misunderstand the differences between temperature and heat, although these are related. Substances are composed of many moving molecules that change their speed as they release or gain heat. When we heat a glass of water in a microwave, its molecules start to move more quickly. The velocity increase results in […]
Read more
Lifting Techniques Part 3 - Complex Block & Tackle
This is Part 3 series by Senior Refrigeration Tech (and prolific writer) Jeremy Smith. Pay attention to this one, folks. I know rigging and safe lifting practices may be boring to some of you, but it could very well save your back or your life. Disclaimer This article is written by a technician representing his […]
Read more
loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from