We have discussed DTD (design temperature difference) quite a bit for air conditioning applications, but what about refrigeration? Let's start by defining our terms again. Suction Saturation Temperature The saturation temperature is the temperature at which the refrigerant will be at a given pressure if it is currently changing state. This change of state would […]

I get questions all the time about performing “load calculations” and “rules of thumb” or how to do it properly. This article isn't about load calculation, but the only good answer is to find a quality ACCA-approved Manual J software and get used to using it. You may have heard from others in the field […]

This question was submitted on the site in response to the recent GFCI tip. It's a good question with several possible answers. What do you think? Hey Bryan, I have had a few instances where we are firing off a furnace in a new build with a temporary power pole outside with gfci outlets installed […]