Bonus – The Case for Tamper Resistant Caps w/ James Bowman

James from Rectorseal talks about the IMC codes relating to tamper resistant caps and why you may consider installing them now

Related Tech Tips

Tubing and Piping Support
  Image Courtesy of Eaton SNAP ‘N SHIELD Piping support is covered in Section 305 of the IMC (International Mechanical Code). Once again, the IMC isn't binding, but it is what most local codes are based on. Piping / Tubing Material Maximum Horizontal Distance Between Support Maximum Vertical Distance Between Support Copper Tubing 1 1/4″ […]
Read more
3-Phase Motors—The Basics
Fundamentally, three-phase, alternating current motors are about as simple as a motor gets. The power company produces three phases by spinning magnets. Then, on the other end, we produce electromagnets that spin the motor according to the same 60 cycles per second frequency (60hz). All three phases are 120 degrees out of phase from one […]
Read more
Is a Smaller Suction Line OK? - Suction Line Sizing
In residential, most techs and installers size the suction (vapor) and liquid lines to the stubs on the equipment. In larger built-up systems, sizing the piping is rarely the responsibility of the technician. But what happens if we show up to a job where the lines cannot be (reasonably) replaced because the size is different? […]
Read more

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from