First off, if you've never heard the term “beer can cold,” you are either not in the trade, or you have been living a pretty sheltered existence. I started as a tech apprentice when I was 17 years old, and on my first day in the truck, my trainer grabbed the suction line of a […]

This article is not a full lesson on making a flare, but it will give you some best practices to make a flare that doesn't leak. First off, we need to clarify that very few unitary manufacturers use flares anymore. You will most often find flares on ductless and VRF/VRV systems and in refrigeration. A […]

  Image Courtesy of Eaton SNAP ‘N SHIELD Piping support is covered in Section 305 of the IMC (International Mechanical Code). Once again, the IMC isn't binding, but it is what most local codes are based on. Piping / Tubing Material Maximum Horizontal Distance Between Support Maximum Vertical Distance Between Support Copper Tubing 1 1/4″ […]