Are Refrigerant Additives OK?

By October 4, 2018

Are Refrigerant Additives OK?

John Pastorello the HVAC chemist comes on the podcast and discusses acid inhibitors, oil enhancers, dyes and leak sealants with his knowledge and some things to consider.

Check out our most recent video

Locked Compressors

Our latest Podcast

HVAC School – For Techs, By Techs

Real training for HVAC ( Heating, Ventilation, Air Conditioning and Refrigeration) Technicians. Including recorded tech training, interviews, diagnostics and general conversations about the trade.

In this short podcast, Bryan debunks the myth that electricity only takes the path of least resistance.

It is true that more current will typically take paths of lower resistance; it’s much easier for more electrons to flow through a path with lower resistance, which is consistent with Ohm’s law. Ohm’s law states that a circuit will have higher current with you have lower resistance so long as the voltage stays the same.

In most cases, the voltage stays relatively constant; transformers don’t often need to limit their currents, so there usually isn’t a voltage drop. When power supplies are regulated, the voltage is usually fixed, not the amperage. As a result, dropping the resistance in a circuit will increase the current.

Ohm’s law holds true for both resistive and inductive loads. Inductive loads, however, are a bit tricky because the resistance isn’t constant. As motors spin faster, they create back EMF or impedance, which is magnetic resistance. The resistance only shows up once a motor, solenoid, or another electromagnetic component is energized; the resistance is much more dynamic.

An electrical current takes ALL parallel paths, not just the path of least resistance. The current also stays proportional to the resistance, even when it takes paths of many different resistance values. Our bodies are also parallel paths, so there’s a risk of electric shock even though our bodies usually have much higher resistance than loads. Wet skin has less resistance than dry skin, so that’s why electricity and water are so dangerous to us; lower resistance means that more current can flow through our bodies.

If electricity ONLY took the path of least resistance, we wouldn’t be able to operate all the appliances and electrical components in our homes. The only prerequisite is an electrical potential (voltage).

If you have an iPhone, subscribe to the podcast HERE, and if you have an Android phone, subscribe HERE.

Check out our handy calculators HERE.

Search Episodes

Myth: Path of Least Resistance – Short #154

10/04/2022

Bryan Orr

Dehumidification in Shoulder Seasons w/ Nikki

09/29/2022

Bryan Orr

Time Management – Short #153

09/27/2022

Bryan Orr

Become a Better Mentor w/ Eric Kaiser

09/22/2022

Bryan Orr

HVAC Measurement Types and Benefits

09/15/2022

Bryan Orr

Ventilation and 62.2 Intro & Rant w/ Genry Garcia

09/08/2022

Bryan Orr

Pressure Enthalpy without Tears

09/01/2022

Bryan Orr

Total Heat of Rejection – Short #152

08/30/2022

Bryan Orr

Hard Start vs. Easy Start

08/25/2022

Bryan Orr

Heat of Compression – Short #151

08/23/2022

Bryan Orr

Search Results placeholder

Related Tech Tips

This is Not a Soft Start

I used to call PTCR devices a "Soft Start". I was wrong.

Equipment Grounding

The grounding and bonding process is important, and it's a fairly broad topic. In HVAC/R, we generally just need to make sure that we properly connect the conductors (wires) provided to the proper connection points in the equipment and occasionally the disconnects. These connection lugs or green screws are rated for grounding so long as […]

Technician Profitability: Increase Your Value

We’ve already made a few tech tips and uploaded a few podcasts about HVAC business practices, including some on profitability. That content is all fine and dandy, but those podcasts, articles, and videos may seem out of touch with most of our audience. After all, that content hardly seems to apply to the bread […]

More tech tips