Tony Amadio is a mechanical design engineer at Florida-based engineering firm PE Load Calcs, LLC. He has over 18 years of field experience as an engineer and has also worked in HVACR education. He earned his MSME in Mechanical and Aerospace Engineering from the University of Central Florida.
Double traps are no good. That's the end of this tech tip. Okay, here's some detail: Anytime your drain goes up and down more than once, you have a double trap UNLESS you place an air vent between the two traps that vents ABOVE the drain inlet. The double trap causes drainage issues because air […]
Service calls about condensing fan motor failure are quite common. Even though fan motor replacement is a standard procedure for residential split systems, it requires careful attention to safety and detail. This article will give you a step-by-step guide to replacing condensing fan motors. Along the way, we will also explain a few best practices […]
This website is for professional HVAC techs and those actively learning to become professional HVAC techs, not DIY homeowners. I feel like that needs to be said before I state these seemingly obvious facts, but these very obvious facts are so commonly mistaken that they need to be covered. Take a look at the two […]
NOTE: If you cannot view the recording, the video may still be processing. The maximum wait time is 24 hours. We apologize for the delay and appreciate your patience.
Tony Amadio is a mechanical design engineer at Florida-based engineering firm PE Load Calcs, LLC. He has over 18 years of field experience as an engineer and has also worked in HVACR education. He earned his MSME in Mechanical and Aerospace Engineering from the University of Central Florida.
Tech Tips written:
Event speaker: