The photo above is of a real condenser coil we cleaned. The outer fins looked OK, but dirt and lint were packed deep inside. We also had sky-high head pressure and condensing temperature; those are telltale signs of an impacted condenser. That situation illustrates that a coil can sometimes look OK at first glance but […]

This article was written by Don Gillis with Chemours. Thanks, Don! With the American Innovation Act (The AIM Act) in place and the reduction of the supply of hydrofluorocarbons (HFCs) in effect, the need to retrofit systems with lower global warming potential (GWP) refrigerants will become commonplace in the very near future. So, what does […]

Friction rate is a value located on a ductulator. We use it during the design phase of a duct system to predict the operating static pressure of a duct system. The challenge with friction rate is that it is often misapplied by folks using a rule of thumb (ROT). In order to apply friction rate properly, […]