Matt High-Efficiency Furnace Quiz September 10, 2022, 10:58 pm

Related Tech Tips

Know the Limits of Subcooling
This article was written by RSES CM and excellent market refrigeration tech Jeremy Smith. Thanks, Jeremy! I frequently see techs online struggling with charging or troubleshooting refrigeration equipment and using subcooling as a diagnostic or charging method. Please don't do this unless you understand it fully. Many times, trying to charge a refrigeration system to […]
Read more
Modulation Motors
Modulation motors are not often seen in residential equipment, but we see them a lot in commercial and industrial applications on many different types of equipment. I see them primarily on larger burners to control the fuel firing rate, but they also control water flow through heating coils, the water level on cooling towers, and […]
Read more
It Has a Flat For a Reason
When tightening down a blower wheel or a fan blade on a motor shaft, ONLY tighten it on the flat of the shaft. If you have more than one screw but only one flat surface on the shaft, only tighten the one set screw. Also… Refrain from over-tightening set screws; they need to bite into […]
Read more

Leave a Reply

Your email address will not be published.

This site uses Akismet to reduce spam. Learn how your comment data is processed.

loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from