Irfan Shakh Basic Refrigerant Circuit Course July 9, 2021, 6:25 am

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Related Tech Tips

Technician Profitability: Increase Your Value
  We’ve already made a few tech tips and uploaded a few podcasts about HVAC business practices, including some on profitability. That content is all fine and dandy, but those podcasts, articles, and videos may seem out of touch with most of our audience. After all, that content hardly seems to apply to the bread […]
Read more
Motor Speed - The Basics
How does a typical single phase motor know how fast to run? Typical induction motors are dependent of the electrical cycle rate of the entering power (measured in hertz) for their speed. Our power in the US makes one complete rotation from positive electrical peak to positive peak 60 times per second or 60hz (50hz […]
Read more
Properly Deburring (Reaming)
Deburring copper tubing (often called reaming) is the practice of running a blade around the inside of tubing after you cut it to remove the burr edge from the inside. It's an important practice and should be performed whenever possible. Deburring reduces turbulence inside the lines, as burrs can cause turbulence. HOWEVER… YOU MUST MAKE […]
Read more
loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from