A lot of proper duct design comes down to an understanding of available static pressure and friction rate. We've covered this topic several times on this site and the podcast, but I wanted to focus on this ACCA chart specifically (shown above). If you want a deep dive, I highly recommend listening to my podcast […]

Since I started in the trade, we would take discharge line temperature in the winter on a heat pump system. You can easily check the discharge line in the winter, while suction superheat and even subcool can be more difficult to access. The old-timers who trained me would say that the discharge temp will be […]

Deburring copper tubing (often called reaming) is the practice of running a blade around the inside of tubing after you cut it to remove the burr edge from the inside. It's an important practice and should be performed whenever possible. Deburring reduces turbulence inside the lines, as burrs can cause turbulence. HOWEVER… YOU MUST MAKE […]