adam khan Basic Refrigerant Circuit Course May 25, 2022, 1:46 am

Comments

Related Tech Tips

Cycle Rate Settings - A Quick Review
Most controls and thermostats will have some sort of cycle rate per hour setting that kicks in to prevent over-cycling once the setpoint is reached. These cycle settings don't kick in until the system starts achieving setpoint, so don't worry if it will shut off if it's set to 70° in heat mode and it's […]
Read more
An even EASIER way to check capacitors
In a previous article, we covered the standard way to check capacitors under load. I am now going to give you an even easier test. A properly functioning PSC (permanent split capacitor) or CSCR (capacitor start capacitor run) motor should have a power factor of very close to 1 if they have a properly sized […]
Read more
Understand Dew Point and Absolute Moisture, The Right Side of the Psych Chart
Let's first state the obvious. Most techs are intimidated by psychrometric charts and Mollier diagrams. We JUST ARE. While there are some pretty complicated formulas that back up these diagrams, using them isn't that big of a deal once you understand the different elements and then focus on one at a time. BUT WHY DO YOU […]
Read more
loading

To continue you need to agree to our terms.

The HVAC School site, podcast and daily tech tips
Made possible by Generous support from